MA-660A
1. Special Precautions
1-4
(2) Precautions for Handling
■ Handle the Transformer with care so as not to make an impact such as drop on
it.
■ Do not use this Equipment in the following places:
・damp places (where humidity is higher than 90%),
・hot or cold places (where temperatures is above 40°C or below 5°C),
・places near a high noise source,
・places where chemicals are handled,
・places where water will be condensed,
・dusty places, and
・places at an altitude above 1000 meters.
■ Clean the outside of the Equipment with a soft, dry cloth or one wet with a little
water. If it is very dirty, use diluted neutral detergent or alcohol. Do not use paint
thinner, benzine, etc., since they can discolor or deform the Equipment.
■ Do not put a screw, a coin, etc., in the Equipment, since they can cause a
malfunction.
■ Operate the Equipment according to the method described in this operation
manual.
■ Operate the switches and buttons carefully by hand. If they are operated roughly
or with the tip of a screwdriver, a pen, etc., this will cause malfunction or
damage.
■ Operate the switches and buttons one by one. If two or more are operated at a
time, the Equipment may malfunction or be damaged.
(3) On Disposal
This product incorporates parts containing gallium arsenide (GaAs). At the time
of disposal, separate it from general industrial waste or domestic waste and carry
out the disposal in accordance with applicable laws and regulations.
To Next Page
Loading...
