8
Setback Temps - DD01*
The DD01* and the DigiSmart control can be programmed for 3 different times to activate temperature setbacks. The
current factory default temperature setbacks in v2.5 * software release are: 2º from set point in 30 minutes, 3º in one (1)
hour, and 6º in three (3) hours. For each time, you can select a setback temperature. The amount of setback is the amount
of degrees the control will operate from guest’s setting in degrees F. If a change to the factory default temperature settings
is desired, use the following instructions.
NOTE: When first entering the configuration mode, if you see “ - - ” then you have version 2.5 or higher.
You can verify the software version by starting with the unit in the OFF position, and while holding down the “+”
and “-” buttons , double click the COOL button and then release and push the FAN button within one second.
The unit display will scroll through all of the thermister temperatures and the last item displayed will bs CS
(current software) and you will see 25 for v2.5.
*Other software versions may have different factory setback defaults. Contact your PTAC representative to
determine factory default settings.
WARNING
4. To select first unoccupied set back temperature, press the HEAT key until feature code comes up. To
scroll to a previously viewed feature codes, press the COOL key.
Once you have scrolled to the feature, press either the up or down arrow to scroll to the desired first unoc-
cupied setback temperature. Cooling example: 72
0
(guest set point) + 2
0
(Setback temperature) = 74
0
(operational
set point).
5. Press HEAT key to scroll to first unoccupied setback time. The first unoccupied setback time is the time
between when the control determines that the room is not occupied and when the control sets the operating set
point temperature back. The increments are in hours (.1 = 6 mins., .5 = 30 mins., 1 = 1 hour, etc.). Press either the
up or down arrow to the desired first unoccupied setback time. c
6. To select second unoccupied setback temperature, press the HEAT key until comes up. Press either the
up or down arrow to the desired second unoccupied setback temperature.
Cooling example: 72
0
(guest set point) + 4
0
(Setback temperature) = 76
0
(operational set point).
To Next Page
Loading...
Need help?
General
