ACCESSORIES
48
. This kit is designed to allow terminations of a direct vent furnace
to be "concentrically" vented through a wall or roof. This kit allows a single penetration
to support terminations for both the vent/flue and the combustion air intak
. For use with 34.5" up flow gas furnaces. This kit is intended to
provide a location, external to the furnace casing for installation of a permanent filter.
The rack is mounted over the indoor air blower compartment area of either
. This kit is to be used with 2" - 3" vent systems.
The vent kit must terminate outside the structure. This kit is NOT intended for use with
single pipe (indirect vent) installations.
. This kit is to be used with 2" vent systems. The
vent kit must terminate outside the structure. This kit is NOT intended for use with
single pipe (indirect vent) installation
. Designed for use with furnaces converted to LP gas. The kit
monitors gas line pressure with a pressure switch and will open the circuit to the gas
valve if the LP tank pressure gets low.
Converts a 34.5" single stage furnace to operate on L.P. gas. The
kit contains an L.P. gas valve and a set of six L.P. orifices.
For use when the drain/vent elbow has been removed in a
horizontal left installation. This kit prevents condensate from getting in the inducer and
routes the condensate to a drain. This kit can also be used on the furnace combustion
air inlet to catch condensate.
To Next Page
Loading...
Need help?
General