ACCESSORIES
47
The AFE18-60A control is designed for use where the indoor coil is
located above/downstream of a gas or fossil fuel furnace when used with a heat pump.
It will operate with single and two stage heat pumps and single and two stage
furnaces. The AFE18-60A control will turn the heat pump unit off when the furnace is
turned on. An anti-short cycle feature initiates a 3 minute timed off delay when the
compressor goes off.
P1251305F
P1251306F
P1251307F
P1251308F
ASAS-11
ASAS-18
P1251301F
P1251302F
P1251303F
P1251304F
The High-Efficiency Electronic Air Cleaner is designed to
remove air contaminants down to .01 microns. Carbon filters (optional) remove odors.
Dual indicator lights show unit operation at a glance. Electronic proving switch cycles
the air cleaner On/Off with the system fan. Durable powder-coat paint finish resists
corrosion.
. For use with 34.5" down flow furnace models. These kits
are available for the following furnace widths: 17.5" wide (CFSB17), 21" wide (CFSB21)
and 24.5" wide (CFSB24). The kits must be used to prevent excessive temperature
from reaching combustible materials, if the furnace is installed on a combustible floor.
This subbase effectively separated the furnace base and plenum from combustible
materials. To ensure safe installation, do not install the counterflow floor base directly
on carpeting, tile, or other combustible material other than wood flooring.
A high efficiency air filtration device designed to remove dirt, dust,
pollen and other microscopic particles from the air passing through it. Flexible
performance range up to 2,000 CFM capacity. The air cleaner should be installed in the
system so that all the system air is circulated through the air cleaner. The air cleaner
will only remove the airborne contaminants delivered to it. Maximum performance is
obtained when the system blower is set for continuous operation. Carbon filters
(optional) are available.
To Next Page
Loading...
Need help?
General