© Copyright 2014 Amano McGann, Inc. OPUS7000_Installation_10032014 3
OPUS-7000 Installation Manual
OPUS-7000 INSTALLATION
MANUAL
OPUS-7000 INSTALLATION MANUAL
Introduction............................................................................................................... 5
File References........................................................................................................ 5
BEFORE YOU BEGIN.................................................................................................... 6
1.1 Receiving............................................................................................................ 6
1.2 Removing Packaging Material............................................................................ 7
1.3 Inspecting the Equipment.................................................................................... 8
1.4 Preparing the Site................................................................................................ 8
1.5 Cut Sheets........................................................................................................... 9
1.6 External Drawing................................................................................................. 12
1.7 Internal Drawing................................................................................................. 13
1.8 Architectural Map................................................................................................ 14
1.9 Wiring Conduit (OPUS-7700).............................................................................. 15
1.10 Mounting Diagram............................................................................................. 16
1.10.1 Mounting Instructions.............................................................................. 16
1.11 Specifications................................................................................................... 17
OPUS-7000 PROCEDURES.......................................................................................... 19
2.1 Opening the Paystation Door.............................................................................. 19
2.2 Powering ON the Paystation.............................................................................. 19
2.3 Entering the Management Menus...................................................................... 19
2.4 Removing and Opening the Bank Note Vault.................................................... 20
2.5 Removing the Bank Note Acceptor.................................................................... 21
2.5.1 Checking Bank Note Acceptor Firmware................................................. 22
2.6 Accessing the Coin Vault................................................................................. 22
2.7 Connecting the Ethernet Cable....................................................................... 23
2.8 Installing the Receipt Paper............................................................................. 24
2.9 Removing the Coin Hoppers............................................................................ 25
2.10 Accessing the Coin Dispenser Door............................................................... 26
2.11 Accessing the Bank Note Recylcer.................................................................. 26
2.11.1 Removing the Bank Note Recycler Cassettes....................................... 26
2.12 Inserting a Receipt Header Logo.................................................................... 27
2.13 Enabling the Lost Ticket Button (Negotiated and Flat Fee)............................. 27
VERSION VERIFICATION............................................................................................. 28
3.0.1 Hardware Checklist.................................................................................. 28
3.0.2 Software Checklist.................................................................................... 28
3.1 Verify Current Firmware Versions...................................................................... 28
3.1.1 Windows CE & SmartCash CLM............................................................... 28
3.2 Device Binaries.................................................................................................. 29
3.3 IO-100................................................................................................................ 30
UPDATING SOFTWARE & FIRMWARE...................................................................... 31
4.
1 Updating the Windows CE Image...................................................................... 31
4.2 Updating the SmartCash/CLM Firmware.......................................................... 32
4.3 Updating the IO100.......................................................................................... 33
4.3.1 IO100 Revision r791 and Earlier............................................................ 33
4.3.2 Revision 792 and Above........................................................................ 34
4.4 Updating REPM Firmware................................................................................ 36
4.5 Updating the REPM Imager............................................................................... 37
To Next Page
Loading...
