© Copyright 2014 Amano McGann, Inc. OPUS7000_Installation_10032014 36
OPUS-7000 Installation Manual
4.4 Updating REPM Firmware
Note: Only for devices with current REPM firmware 1.31 and above.
1. Download the REPM update tool from Amano McGann University.
2. Extract the .zip and open the REPM update tool folder.
3. Run the CDM v2.08.30 WHQL Certified.exe driver installation package if the
FTDI driver has not yet been installed. Follow the on-screen instructions.
4. Power OFF the Terminal.
5. Connect the FTDI USB serial cable to the laptop USB and REPM terminal J1
with the black wire on top. The cable is assigned a COM port on the laptop.
[Fig. 4.4A] REPM J1 Terminal
6. Run the REPM Upgrade tool by opening the REPM Firmware Upgrade Tool
folder and double clicking Amano McGann Firmware Download.exe.
[Fig. 4.4B] REPM Firmware Upgrade utility
To Next Page
Loading...
