32
Low battery shows on the
screen.
• Place the handset in the telephone base for recharging.
• Remove and re-install the batteries and use it until fully
depleted, then recharge the handset in the telephone base.
• If the above measures do not solve the problem, replace the
batteries.
The batteries do not
charge in the handset or
the handset batteries do
not accept charge.
• Make sure the handset is placed in the telephone base or
charger correctly.
• Remove and reinstall the batteries, then charge for up to
15hours.
• Purchase new batteries.
Problem Causes Solutions
No dialling tone
when pressing
the <TALK ON>
key
•
The connection cord of the
base station is not plugged in.
• The adaptor cord is not
plugged in correctly in the
base station.
• Another handset is using the
base to make a call.
• Wrong telephone line cord
• Check the connections. Unplug and
plug back in the mains. Check that
the telephone cord has been plugged
into the base station and the phone
socket.
• Check the base station plug and the
230V plug (remove and plug in).
• Wait until the line is unoccupied.
• Use the original telephone line cord
supplied.
When connected
to a PBX, no
and/or wrong
connection after
dialling
• Dialling prefix is needed. • Insert the dialling prefix.
OUT OF RANGE
is displayed
• Base station out of range.
• Base station not connected
to mains.
• Reduce the range.
• Connect the base station to mains.
The call does not
work.
•
Service not activated or wrong
operator or wrong setting.
• Check your subscription with network.
No display. • Empty battery • Recharge battery.
To Next Page
Loading...
Need help?
General