Amazone D9-30 Super - Replacing the WS coulter tip; Replacing the RoTeC coulter wear tip

Cleaning, maintenance and repairs
D9 BAH0007.3 08.10
151
12.13 Replacing the WS coulter tip
1. Push the naps (Fig. 188/1) on the hopper
into the body of the coulter.
2. Pull the hopper out of the body of the coul-
ter.
3. Remove the screw (Fig. 188/2)
(screw tightening torque 4
5 Nm).
4. Lever the coulter tip (Fig. 188/3) out of the
anchorage.
5. Fasten the ne
w shear tip in the reverse
sequence
During installation, make sure that the naps
of the hopper engage in the recesses.
Fig. 188
12.14 Replacing the RoTeC coulter wear tip
1. Remove the plastic disc (Fig. 189/1) (see
"Setting the RoTeC plastic discs", on page
114).
2. Unscre
w the cylinder screw (Fig. 189/2)
(screw tightening torque 30-35
Nm).
3. Replace the wear tip (Fig. 189/3) and install
it in the reverse sequence.
The wear tip (Fig. 189/3) may not
protrude over the edge of the sowing
disc (Fig. 189/4). Replace the sowing
disc if nece
ssary.
Fig. 189