Settings
D9 BAH0007.3 08.10
97
Sowing with bean seed wheel (option)
The bean seed wheels can be
swapped with the normal and fine seed
wheels after removal of the seed shaft or
mounted together with a second seed shaft.
The bean seed wheels must always be fitted in a
specialist workshop (see "Fitting the bean seed
wheels", on page 155).
Fig. 107
8.2 Setting the shutoff gates
1. Remove the calibration cups from the rear wall of the seed box.
2. Set the shutoff gates (Fig. 108) to the value
in the table (see Fig. 48, on page 56).
The shutoff gates (Fig. 108) latch into one of the
three po
sitions:
A
= closed
B = 3/4 open
C = open
3. Close the shutoff gates to the seed wheel
housings that are not required.
Fig. 108
This setting has an effect on the sowing rate.
Check the setting using a calibration test.
To Next Page