“Online”. To download the app, use your mobile device’s camera and scan the Cell Phone Client QR code.
When using the app, use the SN QR Code for quick access to the serial number for your NVR. Click Next.
Camera Registration
The next screen that appears is the Camera Registration screen. This is where you can begin adding
cameras to the NVR. If the cameras are not directly connected to the back of the NVR, please make sure
they are active and on the same network as the NVR before proceeding.
To begin adding a device, click on Search Device to allow the NVR to scan for connected devices on your
network. A list of applicable connected devices will show on the screen. Select your devices by clicking on
the checkbox next to the device and click Add to add the device into the Added Devices menu.
If the status of your camera is red, it indicates the camera is not properly registered to the NVR. This could
be because the password for the camera is not entered properly in the system. To modify the password
for your camera, click on the edit icon (pencil) located in the Edit column in the Added Device menu.
Select the Password field and use the onscreen keyboard to enter the password for your camera. Once
the password has been entered, click Connect then click Save to continue.
Note: If this is a new device and a password has not been added the password will be admin.
Once the password has been properly set the Status indicator will turn green indicating the camera has
been properly added. Once the camera(s) have been successfully added, Click Next.
HDD Manager
The next screen will be the hard drive manager screen. This screen allows the user to verify the hard drive
is being read by the device as well as provides an option to format. Please note, it is highly recommended
to format the hard drive before proceeding.
To format the hard drive, select the hard drive you would like to format from the list and click Format.
Toggle the Clear HDD Database toggle switch on and click Save. Enter the password for the NVR and click
Save. Once the hard drive has been successfully formatted click Save.
Audio Ports
Device Connection
Connect an RCA microphone to the “Audio In” port on the back of the device. If using an audio out device,
such as an RCA speaker, plug the speaker into the “Audio Out” port on the back of the device.
Most audio codecs will use ACC as a default audio codec. To adjust audio settings, log into your NVR and
access the Encode menu for the specific device and click on “More Setting” (Camera > Encode > More
Setting). Verify the codec and settings are correct and click Save to Save the audio settings.
To Next Page
Loading...
