AMD FirePro V7900 SDI User Manual

Enabling SDI
SDI functionality is not enabled by default on your AMD FirePro V7900 SDI. It must be
enabled in the Catalyst™ Control Center software application. Once the AMD drivers
and software have been downloaded and installed (see the installation instructions in
Chapter 4 Software Installation), complete the following steps to enable SDI
functionality.
1. Launch the Catalyst Control Center.
2. Navigate to the AMD FirePro ▷ Serial Digital Interface page.
3. Check the Enable Serial Digital Interface checkbox.
4. Use the slider to select the size of the DirectGMA aperture exposed by the GPU.
22 Software Installation
AMD FirePro™ V7900 SDI © 2011 Advanced Micro Devices Inc.

AMD FirePro V7900 SDI Specifications

General

Brand	AMD
Model	FirePro V7900 SDI
Category	Video Card
Language	English