To Next Page

To Previous Page

There are bus address or interrupt conflicts.

Make sure that the I/O and memory addresses reserved for the graphics board are

not used by other hardware devices. The integrated on-board VGA controller of your

AMD FirePro card uses the following addresses (hex):

•

I/O Address: Standard VGA I/O: 3B0-3DF

•

Memory Addresses: Video RAM: A000-BFFF, Video ROM: C000-C7FF

You cannot change the addresses of your AMD FirePro card. In case of an address

conflict, try to modify the I/O address of the add-on card that causes the conflict.

To support the special graphics processor on the AMD FirePro card, the system BIOS

should automatically assign a system interrupt to the slot where the card is installed.

However, there may be problems if your graphics card does not receive an interrupt

or a system interrupt is used for more than one device. In case of problems, check the

system configuration utility of your operating system for the interrupt assignments.

Workstation Customer Care

If you experience difficulties with your AMD FirePro product, you can contact AMD

Customer Care in the following ways.

Web

The AMD Customer Care Web site has number of helpful resources, including a

knowledgebase of FAQs and the AMD FirePro Workstation Graphics Web Ticket

Submission Page.

The Web site is complimentary and available at all times. The address is

support.ati.com.

E-mail

Customer Care is available by e-mail at tech.support@amd.com. E-mails must have

"workstation-support" in the subject line. This service is complimentary for registered

users.

Reference 31

AMD FirePro V7900 SDI User Manual

Questions and Answers: