AMD Xilinx ZCU670 - Page 57

6. Launch the board user interface applicaon.
On rst use of the board user interface, go to the FMC → Set VADJ → Boot-up tab and click USE
FMC EEPROM Voltage. The board user interface buons gray out during command execuon
and return to their original appearance when ready to accept a new command.
See the ZCU670 System Controller GUI Tutorial (XTP698) and the ZCU670 Soware Install and
Board Setup Tutorial (XTP699) for more informaon on installing and using the system controller
board user interface ulity.
Switches
[Figure 2, callouts 23 and 24]
The ZCU670 board includes the following power, conguraon, and reset switches:
• SW15 power on/o slide switch (callout 24)
• SW3 (PS_PROG_B), acve-Low pushbuon (callout 23)
• SW4 (POR_B), acve-Low pushbuon (callout 23)
• SW5 (SRST_B), acve-Low pushbuon (callout 23)
• SW2 U1 RFSoC PS bank 503 4-pole mode DIP switch (callout 23)
Power On/Off Slide Switch
[Figure 2, callout 24]
The ZCU670 board power switch is SW15. Sliding the switch actuator from the o to on posion
applies 12V power from J50, a 6-pin mini-t connector. Green LED (DS19) illuminates when the
ZCU670 board power is on. See Board Power System for details on the onboard power system.
Chapter 3: Board Component Descriptions
UG1532 (v1.0) March 30, 2022 www.xilinx.com
ZCU670 Board User Guide 57
Send Feedback