Configuring the Intellex
20 Intellex®
Termination
From the Termination Tab, select 75 Ω or Hi-Z for each camera.
• Set the termination to 75 Ω if the loop-through is not being used.
• Select the Hi-Z if the video signal is looped to another device.
Gain Mode
From the Gain Mode tab, adjust video signals that are too bright or dark:
Choose Boost Gain to amplify the video signal.
Reduce Gain: Decrease the video signal
Normal: Default setting
Boost Gain Length of twisted pair wire
Low < 500 ft. (152 m)
Medium < 1000 ft. (305 m)
High < 1500 ft. (457 m)
To Next Page
Loading...
