American Dynamics Intellex - Page 46

Configuring the Intellex
36 Intellex®
4 Set up Camera Selectable Rate:
a Click Use Camera Selectable Rate Mode.
b From the Per Camera Rate tab, move the rate slider for each active camera set the rates.
c Adjust the Minimum, Normal, and Alarm rates individually by adjusting the section of the
corresponding slider.
d Click OK.
Rate slider
Individual sliders.
If you cannot drag
the slider any
further to the right, it
means that you
have used the
maximum recording
capacity.
To regain recording
capacity on a
camera, another
camera’s sliders
would have to be
reduced.
The first number
represents how
much of the
recording capacity
is being used
The second number
represents the total
available capacity.