Appendix D, DEFAULT SETTINGS
D-3
The Auto-Default function on the front-panel Auto Functions menu and the ADF 0
computer command set the model 7270's controls and output displays as above, and
in addition sets the communications interface parameters as follows:-
RS232 Settings
Baud rate 19,200
Data bits 7 + 1 Parity
Delimiter , (044)
Address 1
Character echo On
Parity Even
Prompt character On
Ethernet Settings
IP Address Assignment Manual
IP Address 000.000.000.000
Subnet Mask 000.000.000.000
Default Gateway 000.000.000.000
Computer IP Address 000.000.000.000
USB Settings
Terminator Null, Status & Overload bytes
The ADF 2 computer command sets the model 7270's controls and output displays as
for the ADF 0 command, except that the oscillator amplitude is set to 0 V rms.
To Next Page
Loading...