Remote Operation
5-20 M370430-01 Rev F
Multiple Power Supply Setup
Master Setup:
Configure the master XG by selecting the communication interface
you wish to use to communication with the Master and follow the
setup instruction in this chapter.
Slave Setup:
1. Turn the 9-position mode control to PGM.
is displayed in the output voltage display.
2. Turn the rotary Adjust/Enter control to select “485L” if the
master is using LAN mode, otherwise select and press
the control to enter the setting.
3. Set a unique address. See “Multichannel Address Setting” on
page 5-25.
To Next Page
Loading...