Communications Options
M370430-01 Rev F 6-45
To communicate with the power supply, use the program, National
Instruments Measurement and Automation Explorer (NI MAX).
You Can download the program from http://www.ni.com.
Important: This section uses the National Instruments™ MAX program to
communicate with the XG. This is for demonstration purposes only. Any
software that is capable of addressing a serial device and sending and receiving
text could be used in its place.
Boot up NI MAX and click the Serial & Parallel section. You
should be able to see the port # from which you referenced the
Device Manager earlier. Verify the settings are the same as above
and click Open VISA Test Panel.
To Next Page
Loading...