Operation
Easy Ramp and EasyFlex Ramp Page 35 of 60
5.6 Disembarking a Passenger /
Unloading a Wheelchair
Deploy the ramp (see Section 5.2, page 24).
Swivel the FutureSafe head and back support (optional)
out of the vehicle.
Release the lap belt and the automatic diagonal shoulder
belt with which the passenger is secured (optional).
Slacken the retractor belt reels (see Figure 16, page 32).
Unclip the retractor belts from the fittings (see Figure 5,
page 18).
Detach the retractor belts from the wheelchair.
Switch the motor of an electrically driven wheelchair ON.
Release the wheelchair's parking brakes.
Take up a position behind the wheelchair so that you can
stop the wheelchair safely if it rolls backwards.
ARNING!
Risk of injury through a wheelchair rolling backwards out o
control.
The floor section and the ramp form a slope via which the
wheelchair can roll down out of control. The passenger in
he wheelchair can be severely injured. Material damage
can be caused.
Therefore:
Stand behind the wheelchair to prevent it from rolling
backwards.
Only then operate the rocker switch such that the indica-
tor lamp in the rocker switch lights up.
Operate the rocker switch such that the indicator lamp in
the rocker switch lights up (see Figure 6, page 19).
Accompany the passenger out of the vehicle.
Detach the electrically operated belts from the wheel-
chair.
Allow the electrically operated belts to retract.
Operate the rocker switch such that the indicator lamp in
the rocker switch goes out.
To Next Page
