Why AMF-BRUNS Cassette Lift platform jerks when retracting into the cassette?
If the AMF-BRUNS Cassette Lift platform jerks when retracting into the cassette, it may be caused by: * The cassette lift not being adjusted correctly. For K70 / K90 models: Adjust the switching point for the retract position or adjust the rollers. * For K90 ACTIVE models: The lower valve may be defective.
What to do if AMF-BRUNS Lifting Systems does not lift the platform off the ground?
If your AMF-BRUNS Back-in-Box-Lift doesn't lift the platform off the ground, there could be several reasons. For K70 and K90 models only, the internal carriage might have been pushed back into the cassette. Try fully extending the platform using the cable or wireless remote control, or manually pull the platform out of the cassette. Alternatively, the remote control or Smartphone App may be defective, or the contactor has tripped. In this case, use the emergency operating mode to raise and retract the platform, and have the remote control and contactor checked by a specialist. Also, check the Smartphone and repair or replace it if necessary. Finally, the Back-in-Box-Lift’s electrical or hydraulic system may be defective, and you should have it checked by a specialist workshop.
What to do if AMF-BRUNS K90 ACTIVE neither raises nor lowers?
If your AMF-BRUNS Back-in-Box-Lift neither raises nor lowers, it indicates a defect in the electrical or hydraulic system. Operate the Back-in-Box-Lift in the emergency operating mode and do not use it again. Contact a specialist workshop.
What to do if AMF-BRUNS K90 ACTIVE Lifting Systems platform does not extend?
If the platform of your AMF-BRUNS Back-in-Box-Lift does not extend, first check the vehicle's battery and recharge or replace it if necessary. Also, check the fuses and replace them if necessary. For K70 and K90 models, manually pull the platform out of the cassette and have the latching switch replaced by a specialist workshop.
What to do if AMF-BRUNS Lifting Systems does not lower the platform?
If your AMF-BRUNS Back-in-Box-Lift does not lower the platform, the remote control or Smartphone App might be defective. Check the remote control or Smartphone and repair or replace it if necessary. Alternatively, the lowering valve on the hydraulic aggregate could be defective. In this case, lower the platform using the emergency operating mode and have the lowering valve replaced in a specialist workshop.
What to do if AMF-BRUNS Cassette Lift does not lower the platform?
If your AMF-BRUNS Cassette Lift is not lowering the platform, consider these potential causes: * The remote control or Smartphone App might be defective. Check the remote control or Smartphone and repair or replace it if necessary. * The lowering valve on the hydraulic aggregate may be defective.
What to do if AMF-BRUNS Cassette Lift does not lift the platform off the ground?
If the AMF-BRUNS Cassette Lift does not lift the platform off the ground, here are a few things to consider: * For K70 and K90 models: The internal carriage may have been pushed back into the cassette, perhaps due to the vehicle being parked on an incline. Try fully extending the platform using the remote control. Alternatively, you can manually pull the platform out of the cassette. * The remote control or Smartphone App might be defective, or the contactor has tripped. * The electrical or hydraulic system of the Cassette Lift may be defective.
Why is it not possible to operate AMF-BRUNS Cassette Lift using the Bluetooth remote control?
If you cannot operate your AMF-BRUNS Cassette Lift with the Bluetooth remote control, consider the following: * The Bluetooth remote might not be connected to the receiver. You may need to teach the Bluetooth remote control in once again. * The Bluetooth remote may have automatically switched itself OFF. Press the “Retract” button on the cable-connected remote, then press the “Retract” button on the Bluetooth remote for five seconds. * The remote battery might be discharged. Charge the battery. * The Bluetooth remote control may be defective. Check the Bluetooth remote control and replace it if necessary. * The setup for the first Bluetooth remote control may be lost when teaching in a second Bluetooth remote control. Teach the first Bluetooth remote control in once again.
Why does AMF-BRUNS K90 ACTIVE Lifting Systems platform jerk when retracting?
If the platform jerks when retracting into the cassette on your AMF-BRUNS Back-in-Box-Lift, it might not be adjusted correctly. For K70 / K90 models, adjust the switching point for the retract position or adjust the rollers. For K90 ACTIVE models, adjust the switching point for the retract position.
Why AMF-BRUNS K90 ACTIVE lowers the platform slowly on its own?
If your AMF-BRUNS Back-in-Box-Lift lowers the platform slowly on its own, the lowering valve might be defective and needs replacement by a specialist. Also, check if the ball-cock is open and close it.
Defines the danger zone and necessary precautions to avoid injury.
Details the roll-off guard, signalling systems, and door contact switch for safety.
Notes for preventing injuries and material damage, including safety devices and inspections.
Critical safety rules to follow during the operation of the lift.
Step-by-step guide for safely boarding a passenger onto the lift.
Step-by-step guide for safely disembarking a passenger from the lift.
Procedures for manual operation of the lift in case of electrical failure.
Manual steps to extend the platform when power fails.
Manual operation procedures specific to the K90 ACTIVE model.
Manual procedure for raising the K90 ACTIVE platform.
Manual procedure for lowering the K90 ACTIVE platform.
Manual steps to retract the K90 ACTIVE platform into the cassette.
Essential safety rules before performing maintenance or repair work.
Procedures for testing the proper function of safety devices.
Guidelines for the annual inspection by a technical expert.
Issues with the lift failing to raise, lower, or extend properly.
Platform jerks during extension or retraction into the cassette.
Adjusting the switching cam for proper platform retraction.
General| Brand | AMF-BRUNS |
|---|---|
| Model | K90 ACTIVE |
| Category | Lifting Systems |
| Language | English |
To Next Page
