De-Commissioning and Conservation
Page 58 of 100 Back-in-Box-Lift K70 / K90 / K90 ACTIVE
8 De-Commissioning and Conserva-
tion
For queries regarding de-commissioning and conservation,
contact our customer services department (see Chap-
ter 13, page 98).
9 Faults and Troubleshooting
WARNING!
Danger through carrying out repair work incorrectly.
A number of risks of personal injury and material damage
can be caused if repair work to the Back-in-Box-Lift is not
carried out correctly.
Therefore:
• Only allow specialist personnel to carry out repair work.
If faults occur when operating the Back-in-Box-Lift, pro-
ceed as described in the following troubleshooting table.
Contact the customer service department if faults are en-
countered which cannot be remedied using the information
and measures given in the table.
It is impossible to
operate the lift using
the cable-connected
remote control.
The cable remote control is
defective.
Check the remote control and it’s
connections. If necessary, replace
the remote control.
It is impossible to
operate the lift using
the Bluetooth remote
control.
The Bluetooth remote con-
trol is not connected to the
receiver.
Teach the Bluetooth remote con-
trol in once again (see Section
9.4, page 71).
The Bluetooth remote con-
trol battery is discharged.
Charge the battery (see Section
9.3, page 70).
The Bluetooth remote con-
trol is defective.
Check the Bluetooth remote con-
trol and replace it if necessary.
The Bluetooth control box
is not installed.
Contact the customer service de-
partment (see Chapter 13,
page 98).
To Next Page
Loading...
