Faults and Troubleshooting
Back-in-Box-Lift K70 / K90 / K90 ACTIVE Page 71 of 100
9.4 Teaching the Bluetooth remote
control in
ð Make certain that no other Bluetooth receiver is
switched ON within a radius of 10 m.
ð Press the "Retract" button (1) for longer than three sec-
onds.
The Bluetooth remote control is switched ON.
ð Press the "Retract" (1), "Lower" (3) and "Retract Posi-
tion" (5) buttons simultaneously for at least three sec-
onds, until the "State of Charge" LED (9) blinks.
ð Press and hold the "Retract" button (1) until the "State of
Charge" LED (9) lights continuously and the "Bluetooth"
LED (8) blinks.
ð Press and hold the "Lower" button (3) until the "State of
Charge" (9) und "Bluetooth" LEDs (8) blink simultane-
ously.
ð Press and hold the "Retract Position" button (5) until the
"State of Charge" (9) und "Bluetooth" LEDs (8) blink al-
ternately.
The "State of Charge" LED (9) goes out after approx. five
seconds. The "Bluetooth" LED (8) continues to blink. The
remote control is connected to the receiver.
If the "Bluetooth" LED (8) does not blink, the connection
has failed. If this is the case, repeat the teaching in proce-
dure.
To Next Page
Loading...
