Emergency Mode
Back-in-Box-Lift K70 / K90 / K90 ACTIVE Page 43 of 100
ð Remove the plug. To do this, use the hook provided as
an accessory (see Figure 23).
Figure 23: Removing the Plug
ð Insert the hook 3 to 5 cm into the opening that the plug
was in.
ð Use the hook to pull firmly on the cable that can be seen
through the opening (see Figure 24).
Figure 24: Releasing the Latch
Releasing the latch releases the platform.
ð Keep a firm hold on the cable with the hook.
ð Extend the platform 10 to 15 cm from the cassette (for
the operating controls: see Section 2.3, page 23).
ð Remove the hook from the opening.
ð Fully extend the platform.
To Next Page
Loading...
