S-101
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 09/2004
1-8
Provision is made on this machine to meet any emergency arising during the making of the buttonhole.
To extract work in case of unthreading or mislocation:
Proceed as follows: 1. Press pedal on transmitter to stop belts.
2. Pull lever n in direction of arrow toward operator.
3. Turn R. H. handwheel (knurled rim) in direction of arrow until locked.
4. Move clamp lever o away from operator to release work - and
withdraw it.
5. Pull clamp lever o down again in direction of operator.
6. Press pedal - the machine will now complete its cycle and return to its
starting position without sewing.
A complete cycle under power, including the
cutting operation - may be made without
sewing.
Lift up the lever q and hold - depress the
starting lever p and let go of lever q after the
machine has travelled a short distance - the
machine will thereafter complete its cycle and
cut fabric without stitching. It can be stopped in
any desired position with the transmitter pedal.
MODEL 101 - OPERATING INSTRUCTIONS
To Next Page
Loading...
