e-mail: service@amfreece.cz; parts@amfreece.cz ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 09/2004
S-101
1-7
1. Remove the needle and test it for straightness, insert as below.
Tension discs
Needle bar
Needle holding screw
Insert the needle as high as it will go
(with long groove square with
machine and on same side as is the
tension disc). Tighten this screw
securely!
2. Put on the belts
Caution!
Before power is applied with foot treadle - see that needle bar is at its highest point - locked,
and machine at its most forward position
3. Depress the treadle on transmitter to start belts.
4. Insert work under the clamp arm and feet.
Starting lever
Work
Clamp
feet
5. Depression of the starting lever will complete one buttonhole and automatically release work and
stop.
MODEL 101 - OPERATING INSTRUCTIONS
To Next Page
Loading...
