Ammann APF 12/33 - Load Ing and Trans por Ta Tion

4.2 Load ing and trans por ta tion
4.2.1 Re move the drawbar
The drawbar can be re moved for easy trans port:
• Re move the pins (1).
• Pull the drawbar (2) out wards and re move it.
• In sert the pins (1) back into the holes to se cure them against
loss.
74020000-2 HbmG gnu thci dreV nna mmA 7102/90
De ath ha zard from sus pen ded lo ad!
• It is for bid den to
– walk un der sus pended loads,
– stand un der sus pended loads,
– ride on sus pended loads.
• En sure that no per sons will be en dan gered.
• Only use suf fi ciently strong and se cure load ing
ramps when load ing.
• Check the con tact points (frame, lift ing rings)
be fore use for dam age and wear. Im me di ately re -
place dam aged parts.
• Se cure the ma chine against roll ing or slip ping
off and against tip ping over.
• When load ing, lash ing down and lift ing the ma -
chine al ways use the pro vided lift ing points.
• Af ter loa ding, lock or re mo ve the draw bar.
4. Trans port
48
In ju ry ha zard!
• Do not op er ate the ma chine with out the drawbar.
• Af ter trans port, pro per ly in stall the draw bar
again.