5.1 Loading and transportation
Af ter load ing, the ma chine has to be at tached in place (1).
Use the cen tre-of-grav ity sus pen sion point (2) in or der to lift the
ma chine.
LM22020000-2 HbmG gnu thci dreV nna mmA 8102/20
Only use suf fi ciently strong and se cure load ing
ramps when load ing.
Check the con tact points (frame, lift ing rings) be -
fore use for dam age and wear. Im me di ately re -
place dam aged parts.
Se cure the ma chine against roll ing or slip ping off
and against tip ping over.
En sure that no per sons will be en dan gered.
When load ing, lash ing down and lift ing the ma -
chine al ways use the pro vided lift ing points.
Per sons are in dan ger, if they
• go near swing ing loads or
• stand un der swing ing loads
Lock the tow-bar to load ing and trans port.
5. Transport
52
To Next Page
Loading...
