not use a stateful address configuration protocol. Stateless autoconfiguration does not require any sort of
central management, and is therefore preferable in networks where no management is readily available, such
as a typical home network.
Tunnel 6to4: Enabling this feature, enables encapsulation of IPv6 packets into IPv4 for transport across an IPv4
network. It allows for automatic IPv6-to-IPv4 address translation, and treats the underlying IPv4 network as
one big non-broadcast multiaccess (NBMA) network, rather than a collection of independent point-to-point
links.
For configuring IPv6 Tunnel 6to4 settings, go to Network Settings > Advanced Settings.
To Next Page
Loading...
