3
• Exercise extreme caution when: measuring voltage >20 V // current >10 mA // AC power line with
inductive loads // AC power line during electrical storms // current, when the fuse blows in a
circuit with open circuit voltage > 600 V // servicing CRT equipment.
• Remove test leads from circuit before opening the case.
• Always measure current in series with the load – NEVER ACROSS a voltage source.
Symbols Used in this Manual
N
Battery
W
Refer to the manual
T
Double insulated
X
Dangerous Voltage
F
Direct Current
J
Earth Ground
B
Alternating Current
R
Audible tone
P
Complies with EU directives
>
Underwriter Laboratories, Inc.
Turning the Meter On and Off
• Press the SELECT button for approximately 2 seconds to turn the meter on.
• To turn the meter off, press the SELECT button until the display goes blank.
To Next Page
Loading...
