AMX APEX Destiny 6100 User Manual

10 Programming APEX Destiny 6100 Alarm Panel
Commands Supported by the Apex module (Cont.)
Command Description
Status Keypad status key
Disarm Arm event – fires when the selected partition (1-8) is disarmed
Monitor Keypad Monitor key
F1 Keypad F1 key
F2 Keypad F2 key
Fire Fire
Emergency Emergency
Panic Panic
Speak Word Speak Word Inside or Inside and Outside, with 1 byte argument.
Conditionals
The APEX module supports the following conditional programming for zones and
system state:
Conditionals Supported by the Apex module
Conditional Description
Trigger Zone event – if selected zone number is triggered.
Bypassed Zone event – if the selected zone is bypassed.
Default Zone event – if the zone returns to the default state.
Trouble Zone event – if trouble is detected with the zone.
In addition to the zone conditionals, the following system conditionals will
evaluate to TRUE after the associated physical event occurs: Arm, Disarm, Exterior
Instant, Exterior Delay 1, Exterior Delay 2, Interior Instant, Interior Delay 1, Interior
Delay 2, Restore, Fire, Panic, Silent, Emergency, Duress, AC Fail, AC Restore, Fuse
Trouble, Fuse Restore, Arm With Zones open, Low Battery, Battery Restore, Fail to Arm,
Fail to Disarm, Expander Trouble, Expander Restore.
A state change will only affect the associated conditional. (i.e., the “AC Fail”
message will only affect the AC Status state; all other system states would remain
unaffected).
Menus
Using the menu Autogenerating function in Landmark Designer will produce the
following menu items for PHAST DMS and IMS keypads. These items emulate a
corresponding keypress on the APEX keypad.
Figure 8
Conditionals Supported by
the Apex module
Note
On power-up, the current
state of the system and zone
status is not reported. The
system and zone states are
initially set to “Undefined”.

AMX APEX Destiny 6100 Specifications

General

Brand	AMX
Model	APEX Destiny 6100
Category	Security System
Language	English