Modero S Series G4 Touch Panels
5
Modero S Series G4 Touch Panels Instruction Manual
Cleaning the Touch Overlay and Case
When cleaning the device, do not directly spray the device with cleaning fluid. Instead, spray the cloth and
then apply the cloth to the touch screen.
Do NOT use abrasives of any type to clean the device, as abrasives may permanently damage or remove the
device’s finish.
If the calibration was improperly set and you cannot return to the Calibrate
page (through the panel’s firmware); this firmware page can be accessed via G4
WebControl by navigating to the Protected Setup page and pressing the Calibrate
button through the VNC window.
This action causes the panel to go to the Calibrate page seen above, where
recalibration of the actual touch panel can be performed again using the above
procedures.
A mouse can be plugged into the USB port (on panels that have access to it) and
used to navigate back to the Calibration page. The process of pushing the button
could also be repeated as necessary.
To Next Page
Loading...
Need help?
General
