US FCC Notice (Class A)
The United States Federal Communications Commission has specified that the following notice be brought to the attention of
the users of this product.
Federal Communication Commission Radio Frequency Interference Statement:
“This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.
The user may find the booklet, How to Identify and Resolve Radio-TV Interference Problems, prepared by the Federal
Communications Commission to be helpful.”
This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402, Stock N. 004-000-00345-4.
Use shielded cables. To comply with FCC Class A requirement, all external data interface cables and adapters must be
shielded.
US FCC Notice (Class B)
Federal Communication Commission Radio Frequency Interference Statement:
This equipment complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial envi-
ronment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Shielded cables must be used with this equipment to maintain compliance with FCC regulations.
Any changes or modifications to this product not explicitly approved by the manufacturer could void the user's authority to oper-
ate the equipment and any assurances of Safety or Performance, and could result in violation of Part 15 of the FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
FCC Radiation Exposure Statement for Wireless Models
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for
this equipment must be installed to provide a separation distance of at least eight inches (20 cm) from all persons. This
equipment must not be operated in conjunction with any other antenna.
To Next Page
Loading...
