Anadex DP-9000 User Manual

TABLE 3-5 SUMMARY OF GRAPHICS PROGRAMMING RULES
1. Any character not recognized as a Graphics valid
character will be ignored but may cause printing errors.
2. Anytime more than 100 spaces are to be programmed, it
may be more efficient to close the record with ~ paper
feed and indent to the next print position, i.e., XXX~;
346XXX. Use of the indent for lesser spacing may
degrade vertical registration.
3. The maximum number of print positions for the DP-9000
is 480, DP-900l is 600, DP-9500 is 792, and for the
DP-950l, it is 990.
4. Alphanumeric printing using the built-in character
matrices utilizes the half-dot position to form the
characters. The half-dot position cannot be addressed
in Graphics. Care must be taken to achieve correct
alignment of characters to Graphics in mixed printing.
5. The printer prints bidirectionally, but this logic is
internal to the printer. All programming should be
referenced to the left margin.
6. Closing a Graphics print statement with ASCII numeral ~
causes the data to be printed without moving the paper.
Any ASCII numeral or group of numerals greater than 0
will cause paper feed a number of dot positions equal
to the sum of the numerals.
7. There is no wraparound function in the Graphics mode,
therefore the programmer must take precautions not to
exceed the maximum allowable number of bytes per line.
8. Alphanumeric printing must be terminated with a CR or
other printing record closing code before entering
Graphics.
3-24

Anadex DP-9000 Specifications

General

Brand	Anadex
Model	DP-9000
Category	Printer
Language	English