Anadex DP-9000 User Manual

The fifth line will also give the established
forms length, in this case 42H (66) lines and
line width equal 84H (132) times one tenth of
an inch or in later models (remember S3-2 is
ON), SOH (80).
The sixth line should read AUTO-LF OFF; COMM =
PARALLEL MODE; SKIP @ LINE OOH.
The seventh line is the complete ASCII character
set (may be wrapped-around at the 80th character).
12. Press the POWER switch OFF and connect the data
source to the appropriate connector as described in
Section 2.9. If serial communications is to be used
set S-2 and S-3 as required.
13. Exercise the connnunications link by transmitting
various data to the printer including such configura-
tion changes by communications link as may be signi-
ficant to printer operation. Refer to Section 3 for
instruction.
14. Checkout is complete.
4.3 TROUBLESHOOTING
The following troubleshooting guides are provided to isolate
some of the more common types of problems which can be cor-
rected at the Operator/User level. Troubleshooting to greater
depth is given in the maintenance manual for those with adequate
technical skills and equipment. See the back of this manual for
a list of authorized ANADEX Service Centers available as of the
date of publication of this manual. No attempt is made in this
table to examine or correct programming errors. Refer to
Section 3 for programming examples.
4-4

Anadex DP-9000 Specifications

General

Brand	Anadex
Model	DP-9000
Category	Printer
Language	English