Anadex DP-9000 User Manual

TABLE 4-1. TROUBLESHOOTING (Cont'd)
SYMPTO~1 PROBABLE CAUSE AND ACTION
POWER is ON, ON LINE is ON,
SELF TEST passes but one
of the following is true:
Data from the data source
is not printed.
7.5 second time delay
(Sl-7) is ON.
Printer prints correct data
for approximately the
number of characters equal
to the FIFO buffer size
and then loses data and/or
then prints garbage.
l~-7
Parallel Interface
One or more sections of S3
are ON, except S3-2.
Printer BUSY, IBZ or ACK not
properly connected to data
source.
DSTR strobe from data source
is too late or data from
data source is not on bus
long enough.
Faulty interface cable.
Faulty printer circuit card.
Refer unit to service center.
Serial Interface
Communication is EIA RS-232-C
but S4 is set for TTY
Current Loop or vice versa.
S3-l is not ON.
S3 set for incorrect Baud
rate.
Improper word length, stop
bit or parity condition
set up_
Incorrect protocol setup on
S2. Refer to Paragraph
4.3.1, following, for guide
in establishing serial com-
munications.
Printer BUSY or SRTS (PRINTER
BUSY) not connected to pro-
per pin at data source.

Anadex DP-9000 Specifications

General

Brand	Anadex
Model	DP-9000
Category	Printer
Language	English