VCO1
DETUNE
Use this control to alter the pitch in small amounts to detune relative to the other
oscillators.
PITCH
This control is used to attenuate any modulation signal that you patch into the socket
below.
Examples of modulation signals are outputs from the LFO or EG, or from an external
modular system (eg Eurorack). An audio signal can also be used, such as the audio
outputs from the other oscillators.
PW - Pulse Width
This control allows you to manually change the pulse width of the Square waveform.
PWM - Pulse Width Modulation
Use this control to alter the amount external modulation that you patch into the
socket below.
Examples of modulation signals are outputs from the LFO or EG, or from an external
modular system (eg Eurorack).
Square / Sawtooth
There are separate jack socket audio outputs for the two VCO waveforms.
These can be patched to other circuits, for example, used to modulate the pitch of
another oscillator.
OCT - Octave
Click right to transpose the pitch up one octave.
To Next Page
Loading...