GATE SEQUENCER
The gate sequencer is 8 step. It is used to create 8 step rhythm patterns that are
used to primarily trigger the Envelope Generators.
There are 8 steps and any or all of them can be turned on and off. When a step is on
a gate signal is sent out the GATE jack, or to the envelopes (if selected on the EG
TRIG rocker switches).
To change the gate pattern use the two BEAT controls.
The left BEAT control affects the even ‘down’ beats. And the right control affects the
odd ‘off’ beats.
They each turn on/off 4 steps (beats) each.
When the controls are both fully left you get no gate triggers at all. When fully right
you get all 8 playing.
To Next Page
Loading...