Direction (2 arrows)
There are 2 playback modes.
LED Off
The notes will playback in the order they were programmed in.
LED Solid (continuously on)
The notes will first play back in reverse order.
RANGE
There are 2 playback ranges.
LED Off
The notes will playback as programmed.
LED solid
The notes will playback as programmed, then again an octave higher.
SYNC Switch
This rocker switch selects the sync source for the Sequencer.
Switch Up -
MIDI Note 0 is used as a clock source. Each time MIDI note 0 is played, the
Sequencer will advance one step.
Write a Note pattern in your DAW to create your own custom clock rhythms! Far
more versatile than MIDI Sync.
Switch Down -
LFO is used as the clock source.
The jack socket below is an external clock input. M.CLOCK (MIDI clock) can be
patched into here, or a clock from an external modular system.
Or, use the Gate output of the Patternator as a clock source!
Note: The Sequencer will do nothing if
1/ It is Off.
2/ No MIDI note 0 is received,
3/ There is no clock patched into the Sync socket.
To Next Page
Loading...