D625 Users Manual
MAINTENANCE - Installation Planning Checklist
Mount meter in an area that provides sufficient space for proper piping and process
connections
Installation of a BYPASS and Valves should be considered between the meter and process
connections to facilitate easy removal for periodic maintenance
Plan an adequate location for the REMOTE ELECTRONICS (if applicable) enclosure.
Once you’ve fully planned your installation, the next step is to unpack and assemble your D625
meter.
INSTALLATION DIMENSIONS
The diagrams below outline the overall mounting dimensions for the D625 Density Meter. Please
take these dimensions into consideration. All dimensions shown are in INCHES. Weight is
approximately 16 pounds empty of fluids. ALL DIMENSIONS ARE SUBJECT TO CHANGE
TOP-VIEW DIMENSIONS
All dimensions shown are in INCHES.
FIGURE 2: DENSITRAK D625 – TOP VIEW - DIMENSIONS
FRONT-VIEW DIMENSIONS
All dimensions shown are in INCHES.
To Next Page
Loading...