D625 Users Manual
OTHER INSTALLATION METHODS
MOTOR-DRIVEN PUMP
This installation incorporates a motor driven pump to draw fluid from the customer pipeline. This
installation incorporates ball valves at the inlet and outlet of the densitometer to allow for easy
meter maintenance and service. The pump is installed so that the fluid is “pushed” through the
meter.
TANK INSTALLATION
This installation involves process connections between the density meter and a fluid holding
(mixer) tank. The meter can be installed so that the fluid inside the tank is run through the meter
and then pumped back up into the tank.
There are numerous other methods in which the meter can be installed into your system. Proper
planning of your installation is essential to consistent, accurate, repeatable performance.
To Next Page
Loading...