Andel Floodline 32 - Page 12

FL 128 Multizone System 15.01.2021 12
Alarm Active Indicator
Mute Button
Menu Access Key
Display Window
Up Scroll Key
Menu Key
Down Scroll Key
Enter Key
Leak Alarm
A leak alarm is generated on a per zone bases when the loop resistance of the zone falls below the set limit as
set by the engineer at time of commissioning. When a leak alarm is generated the audible alarm in the control
unit is activated, the alarm indicator on the control unit flashes and the display window indicates the zone in
which the alarm was activated as shown below. The Leak detection relay in the base unit will also activate if the
relays are armed.
L
e
a
k
D
e
t
e
c
t
e
d
Z
o
n
e
1
6
R
O
O
M
1
0
M
o
r
e
A
l
a
r
m
s
The “More Alarms” message displayed on the fourth line will only appear if there is more than 1 alarm active. It
there is more than one alarm active then the up and down scroll keys are used to scroll through the other
alarm events present. To mute the audible alarm, press the mute button on the front on the control unit.