Anderic® RR1298A RF Smart Remote for Samsung® TVs with Voice
Control
Operating Instructions
Installing batteries into the Anderic Smart Remote
To install the batteries, push the rear cover open in the direction of the arrow in the illustration
below. Then insert the batteries as shown in the illustration. Make sure that the positive and
negative ends are facing the correct direction. Replace the battery cover by aligning and sliding
it back into position.
Pairing with your TV:
1. Turn on the TV by pressing the key on the remote.
2. Press and hold the buttons labeled and simultaneously for 3
seconds or more, as shown in the figure below.
a. The indicator light on the remote will flash rapidly.
b. On-screen, the TV should show that the remote is pairing to TV.
Please wait for it to successfully pair. The remote should now have
the ability to fully control your TV.
Note: Only one smart remote can be paired with the TV at a time.
To Next Page
Need help?
General
