To Next PageTo Next Page
Need help?Do you have a question about the Andersen LuminAire and is the answer not in the manual?
General| Brand | Andersen |
|---|---|
| Model | LuminAire |
| Category | Projection Screen |
| Language | English |
Key safety warnings, hazard symbols, and cautions for installation and use.
List of tools required for the installation process.
Steps to measure door width (W1, W2, W3) and height for proper fit.
Check exterior trim for required flat surface depth for screen assembly attachment.
Unpack and arrange housings and screen tracks, aligning labeled ends and sides.
Insert and tighten track stops and install track extenders into passive housing end caps.
Slide receiving tabs on endcaps into screen tracks and ensure proper fit.
Align screen tracks using configuration lines (72" or 68") and secure fastener clips.
Cut plastic wrap and position screen assembly for installation into the door opening.
Secure the Active Housing screw flange to the mounting surface using screws.
Secure the Passive Housing screw flange to the mounting surface using screws.
Mark center points on screen tracks and adjust track stops to the marks.
Adjust screen pull positions and install slot covers into adjustment slots.
Attach corner pile to the passive housing screen pull for smooth operation.
Clean sill, position adapter, insert into channel, predrill, seal, and fasten to door sill.
Measure opening width, calculate material to cut from tracks and sill adapter for narrow openings.
Position and secure blocking under the sill to extend 3/4" from exterior trim.
How to open, close, lock, maintain, and store the screen, and cold weather use.
Information on replacement parts, customer service, and installation videos.
Details the coverage for defects in manufacturing, materials, paint, and workmanship.
Lists items not covered, such as improper installation, accidents, and wear.
