Anderson M-160 - User Manual

Questions and Answers

H
Harry LeonardAug 12, 2025
What to do if my Anderson Farm Equipment loader does not move or lacks power?
- C
  Charles HughesAug 12, 2025
  If your Anderson Farm Equipment loader isn't moving or lacks power, several issues could be the cause. First, ensure the couplings are properly connected and reliable. Next, check the hydraulic oil level, look for leaks, and add hydraulic oil #32 if needed. Also, inspect the strainer at the hydraulic reservoir outlet and clean it if necessary. Finally, if there's a lack of oil pressure, a specialist should check the pressure, and the pump or pressure valve may need repair or replacement. If the oil is too hot, wait for it to cool and add oil if necessary.
L
Lindsay PittsAug 21, 2025
How to troubleshoot an Anderson Farm Equipment engine that won't start?
- J
  Jeremy WalkerAug 21, 2025
  If the engine of your Anderson Farm Equipment hydraulic unit doesn't start, begin by checking if the gas tank is empty and refill it if needed. Then, ensure the fuel valve is open. If the low engine oil sensor is activated, add oil. Inspect the spark plug for clogs or defects, cleaning or changing it as necessary. If the engine is flooded, remove the spark plug, dry it and the cylinder, then replace the spark plug and restart.
T
Tyler HernandezAug 31, 2025
What to do if only one component lacks power on my Anderson Farm Equipment?
- J
  Juan HillAug 31, 2025
  If only one component on your Anderson Farm Equipment lacks power, check the cylinder gaskets for oil leaks and repair them if necessary. Also, have a specialist check the distributor valve for defects and replace or repair it if needed.