Anderson RB-200 - User Manual

Other manuals for Anderson RB-200

Operator's Manual28 pages

Questions and Answers

T
Timothy WilkinsonJul 31, 2025
What to do if wrapping with the plastic film is not working well on Anderson RB-200 Farm Equipment?
- D
  David McmillanAug 1, 2025
  If the plastic film is breaking, being punctured, or tearing during wrapping on your Anderson Farm Equipment, inspect the film roll for damage and replace it if necessary. Also, ensure the film roll is installed correctly. Check for any obstructions blocking the stretcher, clear them, and clean the stretcher. If the film is too fragile or damaged from sun exposure, install a new roll. Finally, examine the stretcher components for good condition and repair them if needed.
S
Shelly GarciaAug 5, 2025
What to do if the plastic film wrapping is not adequate on my Anderson Farm Equipment?
- S
  shannontrevorAug 5, 2025
  If the plastic film wrapping isn't adequate, several factors could be at play. First, examine the roll of plastic film for any damage and replace it if necessary. Next, check if hay or any other object is obstructing the stretcher and clear it. If the film is too fragile or damaged from sun exposure, install a new roll. Also, ensure the film roll is correctly installed. Lastly, inspect the stretcher parts for their condition and repair them if needed.
R
Robert BrownAug 9, 2025
Why is the rotating table not turning or turning slowly on my Anderson RB-200 Farm Equipment?
- W
  wendy00Aug 9, 2025
  If the rotating table on your Anderson Farm Equipment isn't turning or is moving slowly, first check the hydraulic oil level for any oil leaks or damage and add hydraulic oil to the tank. Also, verify that the tractor's flow rate is at the appropriate level (8 gpm).
R
Robert BennettAug 14, 2025
What to do if Anderson RB-200 IG-C3 counter turns on, but does not count the rotations?
- W
  walshsusanAug 14, 2025
  If the IG-C3 counter on your Anderson Farm Equipment turns on but doesn't count rotations, check the wiring and connections. If the wiring is not the problem, replace the sensor.
B
brownheatherAug 18, 2025
Why is the rotating table on my Anderson RB-200 Farm Equipment not turning or turning slowly?
- D
  Dawn StevensonAug 18, 2025
  There are a couple of reasons why the rotating table might not be turning correctly. One possibility is that the hydraulic oil level is too low. Check for any oil leaks or breaks, tighten or repair them if necessary, and add hydraulic oil to the tank. Another reason could be that the tractor's flow rate (GPM) is too slow, so verify that the tractor's flow rate is at least 8 GPM.
A
Audrey BriggsAug 22, 2025
How to fix an IG-C3 counter that lights up but doesn't count turns on Anderson RB-200?
- L
  Lance Calhoun MDAug 22, 2025
  If the IG-C3 counter lights up but isn't counting turns, the issue might stem from a defective sensor, wiring, or connection problem. Begin by thoroughly checking the wiring and connections. If everything appears to be in order, consider replacing the sensor.
J
James ClaytonAug 27, 2025
How to troubleshoot an IG-C3 counter that is not lighting up on Anderson Farm Equipment?
- D
  Dana BlakeAug 27, 2025
  If the IG-C3 counter isn't lighting up, the problem is likely due to a lack of power. To resolve this, install the provided a.c./d.c. charger or the module's power cord.