What to do if the plastic film wrapping is unsatisfactory on Anderson RB-400?
If the plastic film breaks, develops holes, or tears during wrapping, inspect the roll for pre-existing damage and replace it if necessary. Also, check for any obstructions in the film stretcher, remove them, and ensure all rollers turn freely. It could also be that the film is too soft from sun exposure; try using a cooler roll.
How to fix plastic film that is not tight enough on the bale with Anderson RB-400?
To resolve this, check if the plastic film roll is properly installed. Also, inspect the parts of the plastic film stretcher to ensure they are in good condition and turn freely; repair as needed.
Why does the turntable not turn or turns slowly on my Anderson RB-400 Farm Equipment?
If the turntable on your Anderson Farm Equipment does not turn or turns slowly, check for oil leaks and breaks, and retighten or repair as needed. Add hydraulic oil to the tank. Also, ensure the tractor’s flow rate is at the recommended 8 GPM.
What to do if the IG-C3 counter turns on but does not count revolutions on Anderson RB-400?
If the IG-C3 counter on your Anderson Farm Equipment turns on but does not count revolutions, examine the wiring and connections for any issues. If the wiring is intact, consider replacing the sensor.
How to turn on the IG-C3 counter on Anderson RB-400?
If the IG-C3 counter on your Anderson Farm Equipment does not turn on, ensure that it is receiving power by installing the provided AC/DC charger or the charge wire on the module.
Guidelines for safe operation, hazard identification, and operator responsibilities.
Procedures for secure tractor attachment, maintenance, and hydraulic oil safety.
Regulations and recommendations for transporting the machine on public roads.
Steps to take at the end of the workday, including fuel valve closure.
Provides the exterior dimensions (width, height, length) and total weight of the wrapper.
Daily checks and instructions for installing the plastic film roll.
Testing the film stretcher and adjusting support rollers for different bale sizes.
Guidance on transporting the machine and essential safety measures during operation.
Description of the bale counter's characteristics and operation menu.
Advanced programming for the bale counter and starting the bale wrapping process.
Steps for completing bale wrapping, unloading, and adjusting sensors.
Overview of maintenance requirements, including grease gun lubrication points and frequency.
Details on other lubrication points and cleaning procedures for the machine.
General| Brand | Anderson |
|---|---|
| Model | RB-400 |
| Category | Farm Equipment |
| Language | English |
To Next Page
