8
RC-9018C <Optional> Operation Overview
Power Saving Mode
If you set "Powersave dsply" to "Yes" ( p.24),
unnecessary power consumption by the remote
controller is prevented. If approximately ten minutes
pass without using hot water or without pressing a
button, the display of the remote controller turns off.
This setting is adjustable
p.24
[When using only one water heater:]
It is possible to set the remote controller to
alert the user when the
water delivery volume
has reached a
preset fill volume.
p.32
It is possible to lock
remote controller
operation.
p.22
It is possible to
automatically turn
the water heater
“ON” or “OFF”.
[
For recirculation systems (
)]
It is possible to circulate hot water only
during preferred times of day.
p.20
p.28
The initial setting is set to "Powersave dsply : No-1"
* If you use hot water or press a button, "Powersave dsply" is released.
If you press the PROG button only once, "Powersave dsply" is released and the automatic
program function will operate.
* If the setting temperature is set to 55°C or more, "Powersave dsply" will not function to prevent
accidental scalding.
* If "Recirc" is operating, "Powersave dsply" will not function.
The display turns off
(operation is "ON")
Basic operation
To Next Page
Loading...
