EasyManua.ls Logo

Anetic Aid QA3 - Page 6

Anetic Aid QA3
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction
Document No. 992012. Issue 16 12.01.21
Page 3
When leaving a patient unattended, always switch off the DRIVE assist function and
apply the brakes.
Do not release the trolley down a slope and rely on the DRIVE wheel brake to control
the trolley descent.
Ensure there is nothing to impede the raising or lowering of the patient platform,
backrest, or KneeFlex as this could result in damage to the equipment and/or injury
to the patient.
Incompatible mattresses can create hazards; only replace the mattress with a new
mattress supplied by Anetic Aid, or your authorised dealer, to ensure compatibility in
accordance with BS EN 60601-2-52:2010+A1:2015.
Disinfectant products are corrosive in nature; failure to properly wash and dry the
trolley surfaces could leave a corrosive residue which may cause damage to the
trolley.
Do not use concentrated bleaching disinfectant solutions, organic solvents, abrasive
powders or expose any part of the trolley to excessive heat.

Table of Contents

Related product manuals