Need help?Do you have a question about the Angelo Po FX61E2 and is the answer not in the manual?
Describes how the vent valve is controlled for convection cooking.
Explains vent valve control for combi and steam cooking.
Lists components for drain cooldown in Level 3.
Lists components for drain cooldown in Level 2.
Describes the general layout of electronic boards for Level 3.
Shows connections for control panel and power board.
Identifies combustion and blower control boards.
Shows CPU, LCD, Keyboard, and LED boards.
Details PCB components and their interconnections.
Describes the function of the CPU board.
Describes the function of the power board.
Explains how to enter the service menu with a password.
Explains SW and FW version information.
Describes how to configure the oven type after board replacement.
Lists oven models and their corresponding configuration settings.
Details the steps for oven configuration and troubleshooting.
Explains how to access and interpret the alarm log.
Setting the water hardness parameter for washing.
Procedure for updating oven software and firmware.
Procedure for updating parameters after board replacement.
Setting oven number and APGC testing procedure.
Setting the oven language on initial startup.
Procedure to restore the factory password.
Table detailing procedures after replacing specific components.
Explains the inverter's role and features.
Shows Level 2 control panel and power board.
Shows Level 2 CPU and keyboard boards.
Details communication between CPU and power boards.
Procedure to set temperature units (°C or °F).
How to display software and firmware versions.
Procedure for updating parameters for 2nd gen boards.
Steps for updating software using a USB stick.
Lists oven models and their corresponding configuration settings.
Procedures after replacing CPU, Power Board, Inverter, etc.
Lists fuses for the power board.
Details fuses for wiring, electric, and gas models.
Explains the principles of the premixed gas system.
Describes how air and gas are mixed by fan speed.
Details modulation and minimum power settings.
Illustrates the components of the gas system.
Steps to perform the gas system setup wizard.
Explains burner control board diagnostic modes and blinking codes.
Steps for replacing gas nozzles for conversion.
How to select the gas type in the oven's interface.
Initiating the gas test wizard.
Selecting the gas type during the test.
Choosing the burner for testing.
Viewing fan blower speed parameters during the test.
Initiating the gas test.
How to adjust gas board parameters (requires service).
Lists and describes components of the washing circuit.
Outlines the sequence of a typical washing cycle.
Describes different washing program types (Soft, Basic, etc.).
Explains safety mechanisms like water pressure switch and level sensor.
Details the 4 steps of the clean test procedure.
Lists components of the Level 2 washing circuit.
Step-by-step guide to replace the encoder.
Steps to remove the LCD screen and display.
Describes alarms related to water availability and pressure.
Describes alarms related to gas supply or flame detection.
Alarm for oven door opening or closure request.
Alarms indicating cooking chamber probe failure or disconnection.
Alarms for product core probe failure.
Alarms for steam discharge probe failure.
Alarm indicating a problem with the power board.
Alarm indicating vacuum probe failure.
Alarm for electronic circuit board diagnostics.
Alarm indicating an oven configuration error.
Alarm when the core probe is not inserted.
Alarms for electronic board diagnostics and interference.
To Next Page
General