Need help?Do you have a question about the Angelo Po FX101E3 and is the answer not in the manual?
Details access and functions within the oven's service menu.
Identifies and describes the key components of the gas system.
Explains the step-by-step logic operation of the blower control board.
Describes the GAS alarm F4 for flame missing.
Procedure for setting up the gas system.
Step-by-step guide for gas setup wizard.
Details adjustment procedures during gas setup testing.
Troubleshooting common issues during gas setup wizard.
Guide to solving gas alarms and burner issues.
Table listing washing cycle control alarms and their solutions.
Procedure for replacing CPU and display LCD boards (LIV.3).
Replacing CPU and display LCD boards (LIV.3) 2nd version.
Schedule for recommended maintenance tasks.
No water in the chamber, or water pressure too low.
No water in the drain, or water pressure too low.
No mains gas, or gas pressure too low, or flame detection failure.
Oven door opening or closure request.
Cleaning alarm (W01, W02).
Cooking chamber probe has failed or is not properly connected (Short circuit).
Cooking chamber probe has failed or is not properly connected (Circuit open).
The product core probe has failed (Short circuit).
The product core probe has failed (Circuit open).
The steam discharge probe has failed (Short circuit).
The steam discharge probe has failed (Circuit open).
The motor operated valve is not positioned correctly.
Safety thermostat failure.
Motor overload tripped.
Power board alarm.
To Next Page
General